Yamaha YFM400FWA 2000 5GH3-AE1 Service Manual page 96

REAR BRAKE ADJUSTMENT
Loosen the locknut 6.
Pull up the brake outer cable and turn the
brake cable adjusting (nut) 7 until the
clearance c is within the specified limits.
NOTE:
Make sure the pin 8 is all the way to the
right of the link plate hole.
Hold the adjusting nut 7 and tighten the
locknut 6.
Turn the brake lever cable adjuster (han-
dlebar) 2 until the rear brake lever free
play d is within the specified limits.
Tighten the locknut (handlebar) 1.
Adjust the select lever control cable.
Refer
CABLE AND SHIFT ROD ADJUSTMENT".
Install the rear brake master cylinder
cover.
WARNING
After this adjustment is performed, lift the
front and rear wheels off the ground by
placing a block under the engine, and spin
the rear wheels to ensure there is no brake
drag. If any brake drag is noticed perform
the above steps again.
*********************************
3 - 37
INSP
ADJ
Clearance c:
1 mm (0.04 in)
Rear brake lever free play:
0.5 ~ 2 mm (0.02 ~ 0.08 in)
to "SELECT LEVER CONTROL