Table of Contents
Advertisement
How to Wire Your Fan - C4 Hand-held Remote (Optional)
If you feel that you do not have enough electrical
wiring knowledge or experience, have your fan
installed by a licensed electrician.
WARNING
To avoid possible electrical shock, be sure electricity
is turned off at the main fuse box before wiring. Note:
If you are not sure if the outlet box is grounded,
contact a licensed electrician for advice, as it must be
grounded for safe operation.
1. Setting the Code: The remote unit has 16 different
code combinations. To prevent possible interference
from or to other remote units such as garage door
openers, car alarm or security systems, simply change
the combination code in your transmitter and receiver.
To set the code, perform these steps.
• Transmitter: remove battery cover.
below arrow and slide battery cover off. Slide code
switches to your choice of up or down position.
Factory setting is all up. Do not use this position. With
a small screwdriver or ball point pen slide firmly up or
down (Figure 10a). Replace battery cover on the
transmitter.
• Receiver: Slide code switches to the same positions
as set on your transmitter (Figure 10b).
Remote Transmitter
Unit Detail
9V
Battery
Figure 10a
Operating Instructions - C4 Hand-held Remote (Optional)
WARNING
Check to see that all connections are tight, including
ground, and that no bare wire is visible at the wire
connectors, except for the ground wire.
operate fan until the blades is in place. Noise and fan
damage could result.
NOTE: Set pull chain to high speed before using the
remote control. To avoid accidental pull chain use,
shorten chain by cutting it 2 to 4 inches below switch
body. You can now use your speed control to select any
of the 3-speeds plus OFF.
1. Operating & Using Remote Transmitter (Figure 13):
Install 9 volt battery (If not using for long periods of
time, remove battery to prevent damage to
transmitter). Store the transmitter away from excess
Press firmly
Receiver Unit Detail
Figure 10b
Do not
NOTE: If fan or supply wires are different colors than
indicated, have this unit installed by a qualified
electrician.
GRN or BARE-GROUND
WH-TO MOTOR N
BLK-TO MOTOR L
BLUE-FOR LIGHT DOWN
2. Installing Receiver in Hanger Bracket:
• Slide remote Receiver into the Hanger Bracket (Figure 11).
• Connect wires as indicated: (Figure 12)
− Green Hanger Bracket and Hanger Ball wires to BARE (ground)
wire.
− BLACK Receiver Unit wire (AC IN L) to BLACK supply wire.
− WHITE Receiver Unit wire (AC IN N). to WHITE supply wire.
− WHITE Receiver Unit wire (TO MOTOR N) to WHITE fan wire.
− BLACK Receiver Unit wire (TO MOTOR L) to BLACK fan wire.
− BLUE Receiver Unit wire (FOR LIGHT DOWN) to BLUE light wire.
• Position all connected wires and receiver antenna to allow
installation of ceiling canopy.
• Using canopy screws threaded into the hanger bracket reinstall
ceiling canopy.
• Restore electrical power.
heat or humidity.
• HI Push Button – high fan speed
• MED Push Button – medium fan speed
• LOW Push Button – low fan speed
• OFF Push Button – fan off
• Light Push Button – no function (unless light kit is installed)
8
CEILING
BRACKET
(Open End)
RECEIVER UNIT
NOTE: Receiver wires omitted for clarity
Figure 11
WH-AC IN N
BL-AC IN L
120 VAC SUPPLY
BLK-ANT
(User Supplied)
Figure 12
LO
MED
HI
OFF
9V
Battery
Figure 13
Advertisement
Table of Contents
