Operating With A Load; Lift Load Safely; Before Picking Up A Load - JLG 3507 Operator's Manual

3.3

OPERATING WITH A LOAD

Lift Load Safely

• You must know the weight and load center of every load you lift. If you are not
sure of the weight and load center, check with your supervisor or with the
supplier of the material.
TIP OVER HAZARD. Exceeding lift capacity of the telehandler could damage the
equipment and/or cause tip over resulting in death or serious injury.
• Know the rated load capacities (refer to Section 4) of the telehandler to
determine the operating range in which you can safely lift, transport and place a
load.

Before Picking Up a Load

• Note the conditions of the terrain. Adjust travel speed and reduce amount of load
if conditions warrant.
• Avoid lifting double-tiered loads.
• Make sure load is clear of any adjacent obstacles.
• Adjust spacing of forks so they engage the pallet or load at maximum width. See
"Adjusting/Moving Forks" on page 4-11.
• Approach load slowly and squarely with fork tips straight and level. NEVER
attempt to lift a load with just one fork.
• NEVER operate telehandler without a proper and legible Capacity Chart in the
operator's cab for the telehandler/attachment combination you are using.
3121851
WARNING
Section 3 - Operation
3-5