GE pH/C-900 Operating Instructions Manual page 8

1 Introduction
1.3 Regulatory information
CE marking
The CE marking and the corresponding EU Declaration of Conformity is valid for the in-
strument when it is:
•
•
•
International standards
This product fulfills the requirements of the following standards:
Standard
EN/IEC 61010-1,
UL 61010-1,
CAN/CSA-C22.2
No. 61010-1
EN 61326-1
FCC compliance
This device complies with part 15 of the FCC Rules. Operation is subject to the following
two conditions: (1) This device may not cause harmful interference, and (2) this device
must accept any interference received, including interference that may cause undesired
operation.
Note:
This equipment has been tested and found to comply with the limits for a Class B digital
device, pursuant to part 15 of the FCC Rules. These limits are designed to provide rea-
sonable protection against harmful interference in a residential installation. This equip-
ment generates, uses and can radiate radio frequency energy and, if not installed and
used in accordance with the instructions, may cause harmful interference to radio
8
used as a stand-alone unit, or
connected to other products recommended or described in the user documentation,
and
used in the same state as it was delivered from GE, except for alterations described
in the user documentation.
Description
Safety requirements for electrical
equipment for measurement,
control, and laboratory use
Electrical equipment for measure-
ment, control and laboratory use
- EMC requirements
The user is cautioned that any changes or modifications not expressly approved
by GE could void the user's authority to operate the equipment.
Notes
EN standard is harmonized
with EU directive
2006/95/EC
EN standard is harmonized
with EU directive
2004/108/EC
Monitor pH/C-900 Operating Instructions 29-0549-25 AB