Removing The I/O Expansion Slot Cover - Compaq ProLiant DL760 Maintenance And Service Manual

2-42 Compaq ProLiant DL760 Servers Maintenance and Service Guide
Bus
Primary
Secondary
Tertiary
Note 1: All PCI-X Buses support PCI expansion boards at 33 MHz.
Note 2: The Bus speed will only run as fast as the slowest board installed.
NOTE: The I/O expansion board slots are numbered from right to left as you face the front of the server.

Removing the I/O Expansion Slot Cover

To remove the I/O expansion slot cover:
1. Press down on the top of the expansion slot release lever
2. Remove the expansion slot cover
Figure 2-37. Removing the I/O expansion slot cover
Reverse steps 1 and 2 to replace the I/O expansion slot cover.
Bus Distribution of PCI Hot Plug Slots.
PCI Hot Plug Slot No
through
Slots

Slots through


Slots through


Slots and
Slots and
1
2
Table 2-7
Associated PCI Bus and Bus Speed
PCI Bus 1 (64 Bit), 33-MHz
PCI-X Bus 2 (64 Bit), 50-MHz

PCI Bus 2 (64-Bit), 33-MHz

PCI-X Bus 3 (64 Bit), 100-MHz
PCI Bus 3 (64-Bit), 33-MHz, 66-MHz


.

3
and push the lever up .