2-48 Compaq ProLiant DL760 Servers Maintenance and Service Guide
To remove a hot-plug fan from the server:
1. Perform the preparation procedures. See "Preparation Procedures" earlier in this chapter.
2. Open the top access panel. See "Top Access Panel" earlier in this chapter.
3. Press in the locking latches
module
Figure 2-43. Removing a hot-plug fan
Reverse steps 1 through 3 to replace a hot-plug fan.
CAUTION: Never remove both hot-plug fans while the server is powered up. Overheating and
damage to hardware could result. If the appropriate Compaq software drivers are installed, the
operating system software will initiate a power shutdown in the event of overheating.
and remove the failed hot-plug fan (either 1 or 2) from the
.
2
1