After replacing the Cache Accelerator, complete the following steps to clear the Cache
Accelerator POST Error 220:
1. Reboot the server and press the F9 key to enter the ROM-based Setup Utility.
2. After you are in the utility, select Advanced Options.
3. Select Set Cache Accelerator Corrected.
4. Select the slot, either 1 or 2, that has been corrected.
5. Press the ESC key twice, and then press the F10 key to save.
The bit in NVRAM is cleared at this point. If the Cache Accelerator replacement has been
successful, the POST Error 220 should no longer appear at reboot.
Processor Board
The processor board is located at the bottom of the Processor and Memory Module and should
not be removed. If there is a need to replace the processor board, a new processor module with
system board must be ordered. The new processor board will be attached to the bottom of the
module, along with processor guide rails.
Removal and Replacement Procedures 2-37