Table of Contents
Advertisement
Before you remove the bezel, read "Safety" on page iii and "Installation guidelines" on page 25.
To remove the bezel, complete the following steps.
Step 1.
Insert a flat-blade screwdriver into one of the grooves along the right edge of the bezel.
Step 2.
Carefully pry the bezel away from the storage expansion node.
If you are instructed to return the bezel, follow all packaging instructions, and use any packaging materials
for shipping that are supplied to you.
Continue to "Replacing the bezel" on page 35.
Replacing the bezel
Use these instructions to install a replacement bezel on the storage expansion node.
Before you install the bezel, read "Safety" on page iii and "Installation guidelines" on page 25.
To install the bezel, complete the following steps.
Step 1.
Align the two posts on the front of the storage expansion node with the corresponding holes on
the back of the bezel.
Step 2.
Press the bezel until it clicks into place over each of the posts.
Removing the rear bulkhead
Use these instructions to remove the rear bulkhead from the storage expansion node.
.
Chapter 5
Removing and replacing components
35
Advertisement
Table of Contents
