Table of Contents
Advertisement
3. Carefully lay the storage expansion node assembly on a flat, static-protective surface with the cover
side down and the storage expansion node bezel facing you.
To remove the cam handle, complete the following steps.
Step 1.
Locate the screw that attaches the handle to the storage expansion node.
Step 2.
Using a T15 Torx screwdriver, remove the screw from the handle.
If you are instructed to return the cam handle, follow all packaging instructions, and use any packaging
materials for shipping that are supplied to you.
Continue to "Replacing the cam handle" on page 28.
Replacing the cam handle
Use these instructions to install a replacement cam handle on the storage expansion node.
Before you install the cam handle, read "Safety" on page iii and "Installation guidelines" on page 25.
This procedure requires only the cam handle and the larger of the two screws that are provided in the
expansion node cam handle kit.
To install the cam handle, complete the following steps.
Step 1.
Orient the handle so that the blue release latch is toward the middle of the storage expansion node.
Step 2.
Align the hole in the handle with the hole on the storage expansion node where the handle is
to be installed.
28
Flex System Storage Expansion Node Installation and Service Guide
Advertisement
Table of Contents
