Run The Reactivation Programme - Miele IR 6002 Operating Instructions Manual

,
There will be a small amount of
residual water in the cap. Take care
as it may be hot from the previous
programme.
^ Screw the salt container firmly onto
the socket.

Run the reactivation programme

^ Close the door.
^ Open the stopcocks.
^ Select the REACTIVATION
programme.
The programme will run automatically.
Then:
^ Switch off the machine.
^ Carefully unscrew the salt container,
making sure any water pressure still
remaining can depressurise. Do not
use force!
If the container will not come off
manually please contact the Miele
Service Department.
^ Replace the cap.
^ Select and start the COLD WASH
programme to flush out any excess
salt from the softener unit and from
the cabinet.
^ Push the mobile unit back into the
cabinet.
^ Turn off the stopcocks.
^ Empty the salt container. Do not
empty it into the wash cabinet.
^ Rinse the salt container and filter
insert with clean water.
The water pressure (flow pressure at
the take off point) must be at least
150 kPa (1.5 bar) for cold and hot
water.
If it is below150 kPa (1.5 bar) or if it
fluctuates a lot, the water softener
will not work properly. After
reactivation, salt remains may still be
found in the salt container.
To use up salt remains and to rinse
out the water softener, the
REACTIVATION programme must be
carried out again.
Water softener
17