30 COLLISION INFORMATION
3. Mix a 1/2 gallon water with 1/8 teaspoon dish soap
and pour into spray bottle, this will be used as the de
cal application solution.
4. With the use of the spray bottle (1), wet the vehicle
surface area (2) with decal application solution.
5. Place the decal on a clean, flat surface with the liner
side up.
NOTE: Do not touch the adhesive area of the decal (1),
as this could adversely affect adhesive bond
6. Remove decal paper liner (2) by holding outer pre
mask (3) and slowly pulling back the paper liner at a
180° angle.
7. Spray the adhesive area (1) of the decal liberally with
the decal application solution.
NOTE: Do not make contact with any other surfaces
(ie. floor, clothing etc.) while moving the decal from
work surface to the vehicle
8. Carefully, pick the decal up by the edges of the pre
mask area. Once again paying attention not to make
contact with the adhesive area.
9. Place decal in appropriate location on the vehicle as
described on the premask area (1).
NOTE: If decal does not float / slide into position spray
additional application solution to the vehicle surface
and decal adhesive areas
10. Be certain decal is aligned evenly to objects such as
mirrors, door handles, panel gaps, etc. and that the
decal meets adjoining decal sections evenly.
11. If needed, make necessary adjustments.
2012 FF