Changing The Configuration Stored On The Camera - Sanyo VA-SW3050Lite Instruction Manual

9 Direct positioning screen
When you specify the PAN/TILT angle by
clicking the coordinate on the screen, the
orientation of the camera lens changes
accordingly.
The currently specified location is indicated
by the yellow-green box.
PAN
PAN: 0° - 360°
TILT: -5° - 185°
Note:
• The direct positioning function is available
only in the following cases.
Option board type: VA-82LAN
Firmware of camera: Ver. 1.08-00 or
higher
The startup screen shows the firmware
version number during the startup of the
camera.
• Provided that the Auto Flip function is set
on the camera, the lens position (shown as
the yellow-green box) starts moving
upward from below the centerline when
you click the [MEMORY] button for [Preset
Position] located on the camera controller;
this is quite a normal operation while the
Auto Flip function is enabled.
F Close button
Closes the camera controller.
TILT
PAN
TILT
■ Changing the configuration stored on
the camera
You can change the shooting preferences stored
on the camera using the control buttons.
Displays the configuration menu for
the camera.
CAMERA
LENS
PAN/TILT
AUTO MODE
PASSWORD
LANGUAGE
OPTION
ADVANCED MENU
PRESET
MENU
The configuration menu
Moves the cursor up/down in the
configuration menu.
Moves the cursor to the left/right in
the configuration menu or changes
the setting value.
Switches to the next screen or
confirms the setting value specified.
Note:
• This operation is only available for the
cameras that have one of the following types
of option board installed:
VA-20/50/51/80/82LAN
• "Camera Menu Setup" operating privilege is
required (see page 32-6).
• The menus displayed depend on the camera
model. For details, refer to the instruction
manual supplied with the camera.
22
SET y
SET y
SET y
SET y
SET
y
SET
y
SET y
SET
y
OFF
END
example
English