Sanyo VA-SW3050Lite Instruction Manual page 21

1
Click on the video from the camera you
want to operate.
The red frame appears on the selected
video.
2
Click in the tool bar.
Displays the camera controller.
Camera Controller Functions
The controllable functions are limited depending
on the type of camera (or installed option board).
1 Control buttons
Changes the camera orientation
horizontally and vertically.
• In cases where the camera has
no panning/tilting function, you
can use these buttons to
change the settings for the
camera. (see page 22).
Changes the camera orientation
diagonally.
Scans the monitored area end to
end vertically or horizontally, and
stops at the current camera
position.
Starts or stops the sequence,
auto-panning or tour action mode,
respectively.
• The tour action mode is not
available for some models.
Performs automatic focus
adjustment.
Displays the configuration menu
for the camera.
Switches to the next screen or
confirms the setting value
specified.
MEMO:
If the camera has a panning-tilting function,
clicking the video in the single screen mode
changes the camera orientation so that the
clicked point is located at the center of the
image (see page 13).
2 Preset position buttons
Applies the registered
configuration for camera
orientation, zoom status and
focusing position.
• Select the number for
Registers the current camera
orientation along with the zoom
and focus positions as the
preset configuration.
• Select the number to be used
3 Zoom buttons
Zooms in or out.
4 The shooting function buttons
Adjusts the focus.
Adjusts the iris level.
5 ON/OFF buttons for extended settings
(AUX)
Select an appropriate number
from the pull-down menu and
then select the setting between
ON and OFF.
20
registered configuration from
the pull down menu and click
the [GO] button.
for preset configuration from
the pull down menu and click
the [MEMORY] button.
• The zoom magnification
power may vary depending
on cameras.
English