Sanyo VA-SW3050Lite Instruction Manual page 14

Viewing the Live Video
Selecting the Camera to Operate
When a video is clicked, a red frame is displayed
around it showing that the camera has been
selected.
In this software, it is necessary to select a
camera in the following cases:
• When displaying the camera controller
• When outputting voice from the camera
side
• When transmitting voice from the PC
microphone to the camera side
Clicking the video again or clicking another
video deletes the red frame and disables
selection of the camera.
Context Menu Operations
Right-click on the video to display the context
menu.
The following operation commands are available
for the VA-SW3050Lite.
• Information:
Displays the camera information.
• JPEG/H.264 Unicast/H.264 Multicast:
Switches the image compression format.
English
Panning/tilting camera by clicking video
image
If the camera has a panning-tilting function, click
the video in the single screen mode for
exploiting the function.
A
Click on the video.
Clicking the video in the single screen mode
changes the camera orientation so that the
point where you click is located at the center
of the image.
B
Double-click on the video.
Changing the camera orientation and
zooming-in.
C
Pressing down and holding the [Shift] key,
double-click on the video.
Changing the camera orientation and
zooming-out.
Note:
Depending on the tilt angle, the point where you
click on the video may not move to the center of
the image.
13