Verifying Configuration Result - Huawei eSpace IAD208E(M) Quick Start Manual

eSpace IAD208E(M) Integrated Access Device
Quick Start
2. Click Add. Add the digitmap value on the displayed page.
3. Click OK to finish the digitmap configuration.
Step 8
Save the data.
1. Click Next, and the page of System Tool > Save Data is displayed.
2. Click OK to save the data.
3. Click Finish to end the configuration.
----End

Verifying Configuration Result

After the preceding configuration is complete, the IAD is running normally. You can
use the following method to verify the configuration:

If the IAD is running normally, the PWR indicator is steady on, the RUN indicator
blinks one second on and one second off, the uplink WAN indicator is steady on,
and indicators from 1 to 8 are on when a user picks up the phone.

Choose SIP Service Configuration > FXS User. The FXS configuration page is
displayed. View the user registration status. If the state is Registered, it indicates
that the user is registered successfully.

Make calls to verify the correctness of the configuration. If calls can be made or
received successfully, it indicates that the data is configured correctly.
If a fault exists, check whether the data is correctly configured. If the data is correct but
the fault persists, see the Troubleshooting Guide in the CD-ROM to locate the fault.
Issue 04 (2012-06-11) Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
4 Manual Configuration (Web)
15