Push Button Configuration; Pin Configuration - Huawei B2268H User Manual

LTE TDD B2268H
User Guide
device to authenticate the other) in each of the two devices. When WPS is activated on a device,
it has two minutes to find another device that also has WPS activated. Then, the two devices
connect and set up a secure network by themselves.

5.7.5.1 Push Button Configuration

WPS Push Button Configuration (PBC) is initiated by pressing a button on each WPS-enabled
device, and allowing them to connect automatically. You do not need to enter any information.
Not every WPS-enabled device has a physical WPS button. Some may have a WPS PBC button
in their configuration utilities instead of or in addition to the physical button. Take the following
steps to set up WPS using the button.
Step 1
another.
Step 2
configuration utility and locate the button (see the device's User's Guide for how to do this - for
the LTE Device, see Section 5.4).
Step 3
you must press the WPS button for more than three seconds.
Step 4
network name (SSID) and security key through a secure connection to the enrollee.
If you need to make sure that WPS worked, check the list of associated wireless clients in the
AP's configuration utility. If you see the wireless client in the list, WPS was successful.

5.7.5.2 PIN Configuration

Each WPS-enabled device has its own PIN (Personal Identification Number). This may either
be static (it cannot be changed) or dynamic (in some devices you can generate a new PIN by
clicking on a button in the configuration interface).
Use the PIN method instead of the push-button configuration (PBC) method if you want to
ensure that the connection is established between the devices you specify, not just the first two
devices to activate WPS in range of each other. However, you need to log into the configuration
interfaces of both devices to use the PIN method.
When you use the PIN method, you must enter the PIN from one device (usually the wireless
client) into the second device (usually the Access Point or wireless router). Then, when WPS is
activated on the first device, it presents its PIN to the second device. If the PIN matches, one
device sends the network and security information to the other, allowing it to join the network.
Take the following steps to set up a WPS connection between an access point or wireless router
(referred to here as the AP) and a client device using the PIN method.
Step 1 Ensure WPS is enabled on both devices.
Step 2 Access the WPS section of the AP's configuration interface. See the device's User's Guide for
how to do this.
Step 3 Look for the client's WPS PIN; it will be displayed either on the device, or in the WPS section
of the client's configuration interface (see the device's User's Guide for how to find the WPS
PIN - for the LTE Device, see Section 5.4 ).
Step 4 Enter the client's PIN in the AP's configuration interface.
Issue 01 (2014-01-15)
Ensure that the two devices you want to set up are within wireless range of one
Look for a WPS button on each device. If the device does not have one, log into its
Press the button on one of the devices (it doesn't matter which). For the LTE Device
Within two minutes, press the button on the other device. The registrar sends the
Copyright © Huawei Technologies Co., Ltd.
5 Wireless
46