Iad (Sip) Connecting To The Ims - Huawei eSpace IAD208E(M) Quick Start Manual

eSpace IAD208E(M) Integrated Access Device
Quick Start

Choose MGCP Service Configuration > MG to access the MG configuration
page to view the user registration status. If the Registered state is displayed, it
indicates that the corresponding phone is registered successfully.

You can verify calls. If calls can be performed or received successfully, it indicates
that the data is configured correctly.
If a fault occurs, you need to check whether the data is correctly configured. If the fault
persists, see Troubleshooting to locate the fault.

4.4 IAD (SIP) Connecting to the IMS

Users of the IAD208E(M) register with the IMS to implement the voice service. After
configuring data in the IMS, configure data on the IAD208E(M) to implement the
voice service.
Data Preparation
Obtain the following data from the administrator before configuring the data.
Item
IP address of the
IAD208E(M)
IP address of the SIP server
User domain name
SIP user(The SIP user
belongs to the wild group
whose IMPU is
+8657143210000 on the
IMS)
Group User
Procedure
Step 1
View the current protocol mode. Choose Advanced Configuration > Protocol Mode.
The protocol mode setting page is displayed.
Issue 04 (2012-06-11)
Example
IP address: 192.169.1.62
Subnet mask: 255.255.255.0
Gateway IP address: 192.169.1.1
IP address: 192.169.1.40
abc.def.com
user ID: +86571402001
user name: +86571402001@abc.def.com
password: 123456
IMPU: +8657143210000
IMPI: +8657143210000@abc.def.com
password: 654321
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
4 Manual Configuration (Web)
21