Iad (Mgcp) Accessing The Ngn/Ip Pbx Network - Huawei eSpace IAD208E(M) Quick Start Manual

eSpace IAD208E(M) Integrated Access Device
Quick Start

4.3 IAD (MGCP) Accessing the NGN/IP PBX Network

Users of the IAD208E(M) register with the NGN/IP PBX to implement the voice
service. After configuring data on the SoftSwitch, configure data on the IAD208E(M)
to implement the voice service.
Data Planning
Obtain the following data from the administrator before configuring the data.
Item
IP address of the IAD208E(M)
IP address of the default uplink gateway of the IAD208E(M)
IP address of the media gateway controller (MGC)
Domain name (MG domain name) of the IAD208E(M)
Authentication Mode
Authentication Key
Procedure
Step 1
View the current protocol mode. Choose Advanced Configuration > Protocol Mode
to display the protocol mode setting page.
If the protocol mode is MGCP, you do not need to change it. If the protocol mode is SIP,
you need to click MGCP and click OK. The IAD needs to be restarted if the protocol
is switched. The configured data will be lost after switching; therefore, switch the
protocol with caution. The protocol can be switched after about two minutes. You need
to log in to the IAD again and configure data.
Step 2
Enter the typical scenario. Log in to the Web management system, and
click
Step 3
(Optional) Set the network parameters for the IAD208E(M).
1. Click Start, the page of Basic Configuration > Network Parameter is displayed.
Issue 04 (2012-06-11) Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
to start the guide configuration.
4 Manual Configuration (Web)
Example
192.169.1.62
192.169.1.1
192.169.1.70
shenzhen
HW-Mode
12345678
16