Specifications; Dimensions - Phonic iAMP3020DSP User Manual

SPECIFICATIONS

1KHz, 0.5% THD
Output Power 8 ohms
Output Power 4 ohms
Output Power 2 ohms
Input Sensitivity
Input Connector
Signal Through Out
Frequency Response
Speaker Output
Built-in Signal Processors
EQ
Crossover
Delay
Limiter
Scenes
S/N Ratio (20 Hz – 20 KHz)
THD @ 1 kHz (10% Rated Output)
Damping Factor (8 ohms)
Slew Rate
Input CMRR
Protection Circuitry
Power Consumption
Dimensions (WxHxD)
Weight
iAMP3020 DSP / iAMP4020 DSP
iAMP 3020DSP
Continuous Output Per Channel
600W
1000W
1500W
0.775 volts +/- 3% for 1 kHz 4 ohm rated power,
0.68 volts +/- 3% for 1 kHz 2 ohm rated power
One Combo Jack (XLR+1/4") per channel
One 1/4" phone jack per channel
One Speakon connector per channel
31-band GEQ, Delay, Limiter, Phase Reverse, System Monitoring,
Crossover, Low Pass Filter, High Pass Filter
HPF, LPF, 3 Xover Types: 12, 18, 24dB/oct
0dB to -50dB (Threshold)
>225:1 - 1 kHz at 8 ohms
Multiple Protection designs against DC bias, thermal fault, load mismatch, etc.
1500W 2Ω LOAD STEREO
483 x 105 x 259 mm
(19.02" x 4.13" x 10.2")
6.8 kg (14.9 lbs)
iAMP 4020DSP
680W
1200W
2000W
10Hz – 50KHz
31-band, ±15 dB
0ms to 680ms
8 user-defined slots
> 105dB A-Weighted
Less than 0.1%
> 12V/µs
> -76 dB @ 1 kHz
2000W 2Ω LOAD STEREO
483 x 105 x 259 mm
(19.02" x 4.13" x 10.2")
7 kg (15.4 lbs)
7