Storage - Jacobsen R-311T Parts & Maintenance Manual

Rotary mower with folding rops
Hide thumbs Also See for R-311T:
Table of Contents

Advertisement

Available languages

Available languages

4.22 STORAGE ________________________________________________________________

General
1. Wash the mower thoroughly and lubricate. Repair and
paint damaged or exposed metal.
2. Inspect the mower, tighten all hardware, replace worn
or damaged components.
3. Drain and refill radiator.
4. Clean the tires thoroughly and store the mower so the
load is off the tires. If mower is not on jack stands, check
tires at regular intervals and reinflate as necessary.
5. Keep the machine and all its accessories clean, dry and
protected from the elements during storage. Never
store equipment near an open flame or spark which
could ignite fuel or fuel vapors.
Battery
1. Remove, clean and store battery in upright position in a
cool, dry place.
2. Check and recharge battery every 60 to 90 days while
in storage.
3. Store batteries in a cool, dry place. To reduce the self
discharge rate, room temperature should not be above
80°F (27°C) or fall below 20°F (-7°C) to prevent
electrolyte from freezing.
Engine (General)
1. While the engine is warm, remove the drain plug, drain
the oil from the crankcase, and change oil filter. Install
drain plug and refill with fresh oil. Let engine cool before
storing.
2. Clean exterior of engine. Paint exposed metal or apply
a light coat of rust preventative oil.
3. Add a fuel conditioner or biocide to prevent gelling or
bacterial growth in fuel. See your local fuel supplier.
MAINTENANCE
4. If storing indoors, drain fuel from tank.
5. Close fuel shut off valve.
Cutting Units
1. Wash the cutting units thoroughly, then repair and paint
any damaged or exposed metal.
2. Lubricate all fittings and friction points.
CAUTION
!
To prevent personal injury and damage to the cutting
edges, handle the blades with extreme care.
After Storage
1. Check and reinstall battery.
2. Check or service fuel filter and air cleaner.
3. Check the radiator coolant level.
4. Check oil level in the engine crankcase and hydraulic
system.
5. Fill the fuel tank with fresh fuel. Open fuel shut off valve
and bleed the fuel system.
6. Make certain that the tires are properly inflated.
7. Remove all oil from the reels and bedknife. Adjust
bedknife and cutting height.
8.
Start and operate the engine at 1/2 throttle. Allow
enough time for the engine to become properly
warmed and lubricated.
WARNING
!
Never operate the engine without proper ventilation;
exhaust fumes can be fatal when inhaled.
4
en-27

Hide quick links:

Advertisement

Chapters

Table of Contents
loading

Table of Contents