Knife
2
3
1
Thread cutter
Seam Guide right
1
2
Operating Instructions
Deactivating the knife
⦁
Open the sewing table and the looper cover.
⦁
Press the knife activating knob on/off (1) und turn clockwise (2) until the knife engages
at the lower position.
⦁
Close the sewing table and the looper cover.
Activating the knife
⦁
Open the sewing table and the looper cover.
⦁
Press the knife activating knob on/off (1) und turn counter-clockwise (2) until the knife
engages at the upper position.
⦁
Close the sewing table and the looper cover.
When working with lowered knife, make sure that the fabric edge is not wider
than the selected cutting width. Otherwise the upper looper and the needle can
be damaged.
⦁
After sewing, bring the thread up and pull it over the cutter from back to front.
⦁
Pull the thread down to cut it.
⦁
The chain of thread will be clamped in the thread cutter to be ready for the next piece
of fabric.
3
⦁
Open the sewing table.
⦁
Attach the Seam Guide by adjusting the two hooks on the right
side to the Stitch Plate and then push the Seam Guide down to
the left.
⦁
Sliding the fabric along the right side of the guide provides
constant a cutting distance from the raw edge of the fabric.
⦁
The cutout (3) in the center of the lower mounting bar indicates
the position of the left needle. Scales are provided in mm (1)
and inches (2).
1 Scale in mm
2 Scale in inches
3 Cutout
17