Securing The Thread Chain; Undoing Stitches; Sewing Corners - Bernina L460 Instruction Manual

Securing the thread chain

Undoing stitches

Sewing corners

1 2
3
34
Threading and Sewing
⦁ Leave a 12cm/5" chain at the beginning and the end of the seam so that it can be
knotted or pulled through the first/last few stitches with a darning needle.
To remove stitches already sewn, snip off the needle thread(s) at intervals and pull out
looper thread(s).
1 When reaching the fabric edge, stop stitching (with the needle up).
2 Raise the presser foot and gently pull on the thread chain just so that the stitch plate
is cleared. Turn the fabric, lower the presser foot and begin stitching in the new direc-
tion.
3 When overlocking and trimming at the same time, cut the fabric along the new stitching
line for about 1.5"/3cm in front of the corner.