Foot control
Needle up/down (L 460)
Safety LED L 460
Operating Instructions
⦁
The pressure on the foot control regulates the sewing speed.
After sewing, the needle always stops at its highest position.
⦁
Adjust the up/down position of the needle by sinking the heel back on the foot control.
When the Safety LED is activated, the machine will not run.
Reasons and actions:
►
The looper cover is open.
⦁
Make sure that the looper cover is closed properly.
►
The sewing table is open.
⦁
Make sure that the sewing table is closed properly.
►
The presser foot is up
⦁
Make sure that the presser foot is lowered properly. Do not lift the presser foot
while the machine is in operation.
If overheating should occour, the motor will be cut off and the Safety LED will flash.
►
Switch off the machine for 10 - 15 Minutes to cool down. Afterwards sewing can be
continued.
13