Safety Instructions 1/2 - Wallbox commander Installation Manual

SAFETY INSTRUCTIONS 1/2

Follow all of the safety instructions below and take special care to keep this manual handy. This installation manual is intended for qualified
personnel only.
Do not operate in case of observing physical defects, such as cracks, breaks, corrosion or other damage. In this case please contact your distributor to
get the Wallbox Commander replaced..
Only authorized specialist can open, disassemble, repair, manipulate or modify the Wallbox device. Unauthorized modification of the Wallbox equipment
voids the manufacturer' s warranty.
Unauthorized modifications or conversions are forbidden.
Do not remove any notices on the device, such as safety symbols, warning notices, rating plates, nameplates or cable markings
Install your Wallbox Charger in a position protected from impacts.
The charging station does not have its own power switch. Always follow your local electrical regulations and norms as applicable.
The Wallbox chargers can only be used under the specified operating parameters (Product description) and within the normal environmental
conditions described below:
Environmental conditions¹:
¹ Do not use your Wallbox charger under inclement weather conditions that could a ect either the vehicle or
the Wallbox device. Do not open the connector panel cover in the rain.
COMMANDER
- installation guide
Ambient temperature range
Average temperature (24h avg.)
Storage Temperature
Relative Humidity
-25ºC to 40ºC
< 35ºC
-40ºC to 70ºC
5% to 95% (Non condensing)
en 5