Napa Technology Pristine PLUS CX User Manual page 14

a. Open the bottle and place it on a flat, dry surface.
b. Using the Head Selection T ool (see photo), insert it into
the bottleneck to determine the correct gasket size.
Note:
• The gasket should be fully un-tightened (collar all the way
up, touching the main body) before you insert the head.
• The correct sized gasket should go into the bottle easily
using light pressure. Do not lean on the head or use force,
as this may damage the gasket.
c. T ake a clean dispensing head of the size you selected. Check that the gasket is in good
condition, the cap is properly mounted, and the rotor switch is in the correct position.
(See the "Cleaning and Care" section for more details).
d. Insert a clean pick up tube into the bottle. (It is normal for the upper end of the tube
to extend beyond the tip of the bottle at this point).
e. Insert the upper end of the pick up tube firmly into the opening on the bottom of the
head, as shown. (Keep the rest of the tube inside the bottle while doing this).
f. Carefully insert the dispensing head (with
the pick up tube attached) into the bottle.
The head should go in easily with light
pressure. Do not lean on the head or force
it in, as this may damage the gasket and/or
the top of the glass wine bottle.
Napa Technology Customer Support 800.603.6550
Head Sizing Tool
Page 14