Napa Technology Pristine PLUS CX User Manual page 12

Unpacking and Installing your
3. Power on the WineStation.
a. Plug the power cord (provided) into the power plug on the rear of
the WineStation.
b. Plug the power cord into the grounded 120 Vac.,
60 Hz. electrical outlet. (See Appendix Product
Specifications).
c. Open the door on the front of the system. Swing the spout cover to the up
position.
d. Slide the power switch all the way up to the
e. The WineStation will run through a series of self-tests, which could take up to
approximately 5 minutes. Once this process is completed, the green lights below
the LCD screens will be illuminated, indicating that the WineStation is ready for
service.
f. If the control panel is locked, perform the following steps:
Slide the power switch down one notch to the SERVICE MODE
Push WineStation Service next to any of the displays. Push Exit.
Slide the power switch up to the ON position. The positions will now be un-locked.
Napa Technology Customer Support 800.603.6550
Congratulations!!!
Y ou have completed the Hardware Installation.
Y ou are now ready to set up your wine bottles.
WineStation(s)
position.
ON
Page 12