Maintaining And Replacing Fiber-Optic Cable; Connecting A Fiber-Optic Cable To A Switch - Juniper EX9208 Hardware Manual

CHAPTER 24
Maintaining and Replacing Fiber-Optic
Cable

Connecting a Fiber-Optic Cable to a Switch

Copyright © 2017, Juniper Networks, Inc.
Connecting a Fiber-Optic Cable to a Switch on page 263
Disconnecting a Fiber-Optic Cable from a Switch on page 264
Maintaining Fiber-Optic Cables in Switches on page 265
EX Series, OCX1100, and QFX Series switches support optical transceivers, which are
field-replaceable units (FRUs). You can connect fiber-optic cables to these transceivers.
Before you begin connecting a fiber-optic cable to an optical transceiver installed in a
switch, ensure that you have taken the necessary precautions for safe handling of lasers
(see "Laser and LED Safety Guidelines and Warnings for Switches" on page
To connect a fiber-optic cable to an optical transceiver installed in a switch:
WARNING: Do not look directly into a fiber-optic transceiver or into the ends
of fiber-optic cables. Fiber-optic transceivers and fiber-optic cables connected
to transceivers emit laser light that can damage your eyes.
If the fiber-optic cable connector is covered with a rubber safety cap, remove the cap.
1.
Save the cap.
Remove the rubber safety cap from the optical transceiver. Save the cap.
2.
Insert the cable connector into the optical transceiver (see
3.
338).
Figure 60 on page 195).
263