Epson Stylus C67 Service Manual page 68

EPSON Stylus C67/C68/D68
When installing the Printhead Assy. to the IC Holder, match the
tabs with the notches, and tilt the Printhead as shown below.
Tab and Notch
Figure 4-59. Installing Printhead Assy.
DISASSEMBLY/ASSEMBLY
4.3.3.12 CR Encoder Sensor Board
1) Remove the CR Unit. (p64)
2) Remove the two screws that secure the CR Encoder Sensor Board to the IC
Holder, and remove the CR Encoder Sensor Board.
Tab and Notch
• C.P.B. (P1) 1.7 x 5 :2
Disassembly Procedures
C.P.B. (P1) 1.7 x 5
CR Encoder Sensor Board
Figure 4-60. Removing CR Encoder Sensor Board
Revision A
68