Epson Stylus C67 Service Manual page 63

EPSON Stylus C67/C68/D68
4.3.3.8 CR Encoder Scale
1) Remove the Housing, Upper. (p43)
2) Move the CR Unit toward the center of the printer.
Holder Shaft Unit Step 3)
3) Release the slit on the right side of the CR Encoder Scale from the tab of the
Main Unit.
CR Encoder Scale
Figure 4-46. Removing CR Encoder Scale (1)
4) Remove the CR Encoder Scale from the CR Unit.
CR Unit
CR Encoder Scale
Figure 4-47. Removing CR Encoder Scale (2)
DISASSEMBLY/ASSEMBLY
(See 4.3.3.2 Removing
Slit and Tab
Disassembly Procedures
5) Release Extension Spring 1.494 on the left side of the CR Encoder Scale from
the tab of the Main Unit, turn the CR Encoder Sensor 90 degrees as shown in
the figure, and remove the CR Encoder sensor.
Extension Spring 1.494
Tab
CR Encoder
Scale
Figure 4-48. Removing CR Encoder Scale (3)
When installing the CR Encoder Scale, place the scale so that the
chipped part is facing upper left as shown in the figure below.
Chipped Part
Extension Spring
1.494
Figure 4-49. Installing CR Encoder Scale
Revision A
CR Encoder Scale
63