Epson Stylus C67 Service Manual page 62

EPSON Stylus C67/C68/D68
4.3.3.7 Front Frame
1) Remove the Housing, Upper. (p43)
2) Move the CR Unit to the center of the printer.
Shaft Unit Step 3)
3) Remove both the two screws that secure the Front Frame to the Main Unit and
the Front Frame Stopper.
• C.B.S. 3 x 6: 2
4) Lift up the CR Unit, and remove the Front Frame.
Front Frame
C.B.S. 3 x 6
±
(8 1 kgf.cm)
1
Positioning
Hole and Rib
Front Frame Stopper
Figure 4-45. Removing Front Frame
DISASSEMBLY/ASSEMBLY
(See 4.3.3.2 Removing Holder
CR Unit
C.B.S. 3 x 6
±
(8 1 kgf.cm)
2
Positioning
Hole and Rib
Front Frame Stopper
Disassembly Procedures
Match the positioning hole with the rib as shown in
when installing the Front Frame.
Secure the screws in the order shown in
When you replace Front frame with new one, lubricate it as
A D J U S T M E N T
R E Q U I R E D
specified. See "6.1.3 Lubrication" (p92)
When Front frame is removed or replaced with new one, the
following adjustment must be performed in the order below.
1. "PF Adjustment"
2. "Bi-D Adjustment"
Revision A
Figure 4-45
Figure 4-45.
for details.
62