Epson Stylus C67 Service Manual page 64

EPSON Stylus C67/C68/D68
4.3.3.9 CR Cable Head Cover
1) Remove the Housing, Upper. (p43)
2) When removing the CR Cable Head Cover, follow the steps mentioned below.
1. Slide the CR Cable Head Cover downward, and release tab As.
2.
Release tab B, slide the CR Cable Head Cover upward, and remove the
CR Cable Head Cover.
Tab As
CR Cable Head Cover
Figure 4-50. Removing CR Cable Head Cover
DISASSEMBLY/ASSEMBLY
4.3.3.10 CR Unit
1)
2)
C A U T I O N
3) Disconnect the two connectors from the Main Board.
4) Disconnect the CR Encoder FFC and the Head FFC from the Holder Shaft
5) Disconnect the CR Timing Belt.
6)
7)
Tab B
Disassembly Procedures
Remove the Panel Board. (p54)
Remove the Front Frame. (p62)
As the Head FFC and the CR Encoder FFC is attached to each
other with glue, be careful not to remove them separately.
(4.3.2.1 Removing Main Board Step 1 through Step 3)
CN7: CR Encoder FFC
CN8: Head FFC
Unit. (See 4.3.3.2 Removing Holder Shaft Unit Step 5)
(4.3.3.5 Removing CR Timing Belt Step 3 through Step 4)
Remove the CR Encoder Scale. (p63)
Remove the CR Cable Head Cover. (p64)
Revision A
64