Epson Stylus C67 Service Manual page 45

EPSON Stylus C67/C68/D68
When installing the ASF Unit to the main unit, follow the steps
described below.
1. Make sure to match the guide pin of the ASF Unit with the
positioning hole of the main unit.
2. Make sure to match the shaft of the ASF Unit with the
bearing of the Pump Unit.
3. Secure the screws in the order shown in
Side Surface of the
ASF Unit
Guide Pin
Guide Pin and Positioning Hole
Figure 4-6. Installing ASF Unit
When you replace the ASF unit with a new one, lubricate it as
A D J U S T M E N T
R E Q U I R E D
specified. See "6.1.3 Lubrication" (p92)
When ASF unit is removed or replaced with new one, the
following adjustment must be performed in the order below.
1. "Top Margin Adjustment"
2. "First Dot Adjustment"
DISASSEMBLY/ASSEMBLY
4.3.1.4 Hopper/Retard Roller Unit
C A U T I O N
Figure 4-5.
1)
2) Lift up the Hopper toward the direction of the arrow, release the two tabs, and
Hopper Side
Shaft
Shaft and Bearing
for details.
Disassembly Procedures
Do not touch the cork on the Retard Roller and the Hopper.
Remove the ASF Unit. (p44)
remove the spring and the hopper from the ASF Frame.
ASF Frame Side
Tab
Hopper
ASF Frame
Figure 4-7. Removing Hopper
Revision A
Shaft
Cork
Spring
Retard Roller
45