Motor Wiring And Electrical Requirements - BIRO 922 General Instructions Manual

Hide thumbs

Table Of Contents

Table of Contents

7. Push the green "ON" button. CHECK THE ROTATION OF THE WORM DRIVE SHAFT. ROTATION MUST

BE COUNTER-CLOCKWISE as indicated by the rotation decal affixed to the grinding bowl. ROTATION MUST

ONLY BE CHECKED WITH THE GRINDING WORM REMOVED, otherwise serious irreparable damage may

occur to grinding components. Push red "STOP" button.

8. If machine runs clockwise (backwards), it must be rewired to correct rotation, otherwise serious irreparable

damage may occur to grinding components.

9. Insert worm assembly into grinding bowl, place knife (sharp edges out) onto the square end of the worm

assembly. The breaker plate slides over the worm knife drive pin, and is held from rotating by a pin in the

grinding bowl. Put on the retaining ring.

ONLY HAND TIGHTEN RETAINING RING

For best results, use knife and plate as a set. Do not operate machine for any period of time without product

in the grinding bowl. This will cause heating and dulling of the knife and plate.

10. Check placement of all warning labels and Manual. Machine is now ready for trained operators to process

product.

11. Contact your local Distributor or BIRO directly if you have any questions or problems with the installation or

operation of this machine.

(1) Interchange of current is made in motor outlet box. Leads are properly marked. Changing instructions are

on the motor plate or motor outlet box. Electrical contactor mounted on machine frame must also be

changed to match motor voltage.

(2) All grinders are wired for the voltage as ordered. Be sure motor specifications (voltage, cycle, phase) match

power supply line. Be sure line voltage is up to specification.

(3) Electrical connections to be in accordance with safety codes and National Electrical Code.

(4) Rated voltage of the unit shall be identical with full supply voltage.

(5) Voltage drop on the supply line shall not exceed 10% of full supply voltage

(6) The feederline conductor size in the raceway from the branch circuit to the unit must be correct to assure

adequate voltage under heavy starting and short overload conditions.

(7) The BIRO Manufacturing Company is not responsible for permanent wiring, connection or installation.

(1) All 1 HP motors are dual voltage and can be changed according to wiring diagram on motor nameplate.

(2) Be sure Contactor voltage matches voltage of motor.

(3) Failure to use proper Contactor for motor voltage will cause irreparable damage to contactor.

(4) Install proper plug on power cord for voltage used.