Installation; Uncrating And Set Up - BIRO 922 General Instructions Manual

PROPERLY INSTALL EQUIPMENT IN ADEQUATE WORK AREA
ALWAYS Use Qualified Technician and Electrician for Installation.
ALWAYS Connect to Proper Voltage & Phase.
ALWAYS Install Equipment in Work Area with Adequate Light and Space Away From Children
and Visitors.
ONLY Operate on a Solid, Level, Non-Skid Surface.
NEVER Bypass, Alter, or Modify This Equipment in Any Way From Its Original Condition.
NEVER Operate With Tray And/Or Tray Guard Removed or Manetic Safety Switch By-Passed.
NEVER Operate Without all Warning Labels Attached and Owner/Operator Manual Available to
the Operator.
1. Read this Manual thoroughly before installation and operation. Do not proceed with installation and operation if
you have any questions or do not understand anything in this Manual. Contact your local Distributor, or BIRO
first.
2. Install machine on a level, solid, non-skid surface in a well-lighted work area away from children and visitors.
3. This machine is complete except for a knife and plate. The grinding bowl assembly is packed separately in the
crate. Remove the grinding bowl assembly from the carton. Disassemble the grinding bowl. Assemble the
grinding bowl only into the front of the grinder. Insert and screw in tight the bowl lock handle under the grinding
bowl. Be sure that the back flange of the grinding bowl is tight against the front of the machine. Do not install
grinding worm at this time.
4. Install the feed tray to the top of the grinder. After checking and making sure the power supply is correct, plug in
your machine. NEVER OPERATE MACHINE WITHOUT TRAY INSTALLED. (Machine will not run with tray
removed.)
5. Machine must be properly grounded. Use qualified electrician to install according to building codes.
6. Pushbuttons that activate the internal on/off switch are located on the front of the machine. The interlock safety
switch is mounted inside the machine case toward the front and will break contact with the magnetic starter
should the tray be removed.

INSTALLATION

TO AVOID SERIOUS PERSONAL INJURY

UNCRATING AND SET UP

3