Main Screen - Kohler MPAC 1500 Manual

3.3

Main Screen

The main screen appears at system startup and
displays the following information (see Figure 3-6):
D
System Status (see Figure 3-7)
D
Date and time of the next scheduled exercise run (if
programmed)
D
Measured source voltages
D
Pushbutton functions
Pressing the down arrow button steps to the normal
operation screens shown in Section 3.5. Step through
these screens to check the measured frequency, line
voltages, current (if the current sensing accessory is
installed), and other system information.
Some parameters will appear only under certain
conditions. For example:
D
If no exercise runs are scheduled, the second line of
the main screen is blank.
D
The Daylight Saving Time settings are displayed only
if DST is enabled.
D
Phase rotation and in-phase monitoring are
displayed only for three-phase systems.
D
Some parameters and time delays appear only for
programmed-transition models.
D
The screens displayed during a test or exercise
sequence will vary depending on the time delay
settings.
Pressing the View button steps to the view screens
shown in Section 4.3.
Passwords are required to enter the setup and test
modes. See Section 3.4 for more information about
passwords.
Press the Set button to enter the setup mode.
password is required. See Section 5.5 for system setup
screens.
TP-6714 4/10
Press the Test button to enter the Test mode.
password is required. See Section 3.10.
The display returns to the main screen after 30 minutes
of no activity (no buttons pressed).
LD Exer 12/14 @ 16:00
Norm 480V Emer 480V
B
1. System status message
2. Next scheduled exercise, if programmed
3. Source voltages detected
Figure 3-6 Main Screen
System Status Messages
Maint DIP Switch
Inhibit Transfer
Bypass Contactor Dis
Low Battery Voltage
Fail to Acquire Pref
Fail to Acquire Stby
Fail to Transfer
Module Lost Comm
New Module
Remote Common Alarm
External Battery Low
Phase Rotation Error
Aux Switch Fault
Aux Switch Open
Test Mode Active
Exerciser Active
Peak Shave Active
In Phase Waiting
Figure 3-7 System Status Messages
A
1
System Ready
View Set Test
Section 3 Operation
A
2
3
6446
23