Modes of Operation (Profiles)
Switching the gimbal to different modes of operation (profiles)
•
Press the mode button one time, which is located under the OLED screen to enter Lock Mode (Profile 1):
camera will hold the direction and not follow, pan, or tilt.
•
Press the mode button twice to enter Pan-Follow Mode (Profile 2): The gimbal follows pan and holds the
tilt position.
•
Press the mode button three times to enter Follow Mode (Profile 3): The camera follows the tilt and pan
directions.
•
Press the mode button four times to enter Full Follow Mode (Profile 4): The gimbal will follow roll, pitch,
and pan.
•
Press the mode button five times to enter Profile 5: This will level roll and bring the pitch to the horizon.
•
Press the mode button and hold for six seconds to calibrate the gyroscope.
TIP
Any of the profiles can be set to hold a specific angle or position manually. Take the camera with one hand and
hold it in the desired position for 2 seconds. The system will automatically save the desired angle.
13
2016 Beholder ® All Right Reserved
▲