Modes of Operation (Profiles)
Switching the gimbal to different modes of operation (profiles)
• Press the mode button one time, which is located under the OLED screen (Fig. 9 [3]) to enter Lock
Mode (Profile 1): camera will hold the direction and not follow, pan, or tilt.
• Press the mode button twice to enter Pan-Follow Mode (Profile 2): gimbal follows pan and holds the
tilt position.
• Press the mode button three times to enter Follow Mode (Profile 3): camera follows the tilt and pan
directions.
• Press the mode button four times to enter 3-Axis Follow Mode (Profile 4).
• Press the mode button five times in a row to get to Profile 5: level roll and bring the pitch to the horizon.
• Press the mode button and hold for six seconds to calibrate the gyro.
TIP
Any of the profiles can be set to hold a specific angle or position manually. Take the camera
with one hand and hold it in the desired position for 2 seconds. The system will automatically
save the desired angle (Fig. 10).
Fig. 10. Manual setting on the roll angle
▲
15