Troubleshooting - Chicago Electric 61608 Owner's Manual

Troubleshooting

Problem
Tool will 1. Cord not connected.
not start.
2. No power at outlet.
3. Internal damage or wear.
Tool operates Extension cord too long
slowly. or wire size too small.
Performance 1. Accessory dull or damaged.
decreases
over time.
2. Carbon brushes worn
Excessive Internal damage or wear. (Carbon
noise or brushes or bearings, for example.)
rattling.
Overheating. 1. Forcing machine to
2. Accessory misaligned.
3. Accessory dull or damaged.
4. Motor being strained by
Follow all safety precautions whenever diagnosing or servicing the tool.
Disconnect power supply before service.
Item 61608
Possible Causes
(Carbon brushes or
switch, for example.)
or damaged.
work too fast.
long or small diameter
extension cord.
For technical questions, please call 1-888-866-5797.
Likely Solutions
1. Check that cord is plugged in.
2. Check power at outlet. If outlet is
unpowered, turn off tool and check
circuit breaker. If breaker is tripped,
make sure circuit is right capacity for
tool and circuit has no other loads.
3. Have technician service tool.
Eliminate use of extension cord.
If an extension cord is needed, use one
with the proper diameter for its length
and load. See Table A on page 3.
1. Keep cutting accessories
sharp. Replace as needed.
2. Have qualified technician replace brushes.
Have technician service tool.
1. Allow machine to work at its own rate.
2. Check and correct accessory to
fence and/or table alignment.
3. Keep cutting accessories
sharp. Replace as needed.
4. Eliminate use of extension cord.
If an extension cord is needed, use
one with the proper diameter for its
length and load. See Table A on page 3.
Page 17