Hyundai HYBCF31 User Manual page 24

for brush only.
5.3.9. To prevent overheating NEVER
over cut, instead cut off smaller lengths of
grass or brush. You MUST also remove any
tangled materials – You MUST stop the
machine and remove the HT lead before
carrying out this task.
5.4.1. ALWAYS clear the work area of
cans, bottles, rocks, etc. Flying or whirling
objects may cause serious injury and
damage to users or bystanders. If an
object is accidentally flung out from
machine, immediately stop and check the
machine
5.4.2. Always trim at high speeds.
5.4.3. Maneuverer the cutting head of
the trimmer horizontally from one side to
the other.
5.4.4. Keep cutting deck parallel with the
ground.
5.4.5. DO NOT tilt the nylon cutting head
during operation.
5.4.6. For correct cutting height carry out
a test trim in advance in a test area.
5.4.7. NEVER let the machine run with
damaged or defective parts.
5.4.8. Trimmer is to be used for trimming
grass only. Brush cutter is to be used for
trimming denser vegetation only.
5.4.9. NEVER raise the nylon cutting head
above knee height during operation.
5.4.10. DO NOT use the machine on a
slope or uneven ground or if there is the
chance of slipping or losing the stability.
5.4.11. NEVER over cut – instead cut short
lengths then cut successively lower
heights.
ALWAYS stop the machine before
removing grass deposits. To prevent
overheating of the drive axle remove all
tangled grass and weed fibre. The tangled
grass and weed fibre/s prevent the shaft
from cooling properly. Remove grass
deposits with a screwdriver or similar tool.
5.5. Trimming around trees.
5.5.1. Trim around trees carefully this will
prevent damage to the tree, and tree bark.
5.5.3. Move around the tree in a
clockwise direction. Approach grass/weeds
with the tip of the cutting cord.
5.5.4. To replace worn out cord refer to
2.11. Installing/Replacing cutting
section
cord.
5.6. Extending the cutting cord.
5.6.1. To extend the cutting line run the
motor at full speed and tap the cutting
head on the ground. This will automatically
extend the line. The cord cutter on the
cutting attachment guard will cut the line
to the appropriate length.
Page 24 Ver 4 - September 2016