Table of Contents
Advertisement
With the bump feed facing outwards from your left hand, take the looped end and place it
around the holder in the middle of the spool as shown below.
You will need approximately 3 metres of 2.5 mm of nylon cord
Wrap the nylon cord around the spool in an anti-clockwise direction until you have
approximately - 150 mm (6"). Then insert spool back into the spindle. Feed the line through the
two notches in the spindle and reinsert the washer and spring into the spool. Once complete
re-attach the spindle to the cutting head.
Page 18
Ver 4 - September 2016
Hide quick links:
Advertisement
Table of Contents
