Table of Contents
Advertisement
DVD Changer Mechanism
Removing the DVD Servo control
board
1.
Remove the metal cover.
2.
Remove the DVD changer mechanism assembly.
3.
From bottom side the DVD changer mechanism
assembly, remove the one screw 1 retaining the DVD
servo control board.
4.
Disconnect the card wire, from the connector CN101,
on the DVD servo control board.
5.
Disengage the two engagements "A", remove the DVD
servo control board.
Removing the DVD tray assembly
1.
Remove the front panel assembly.
2.
Remove the DVD changer mechanism assembly.
3.
Remove the DVD servo control board.
4.
Remove the screw 2 retaining the disc stopper.
5.
Remove the three screws 3 retaining the T. bracket.
6.
From the T. bracket section and clamper base section
"B", remove the edges fixing the rod.
7.
Remove the screw 4 retaining the clamper assembly.
8.
From the blacket section "C", remove the clamper ass'y.
9.
From the left side face of the chassis assembly, remove
the one screw 5 retaining both of the return spring and
lock lever.
10.
By removing the pawl at the section "D" fixing the return
spring, dismount the return spring.
11.
Remove the three lock levers.
T. Bracket
3
C
Clamper ass'y
Fig.3
(See Fig.1)
(See Fig.2~4)
(See Fig.3)
(See Fig.3)
(See Fig.2)
(See Fig.3)
(See Fig.3)
(See Fig. 4)
(See Fig.4)
(See Fig.4)
Disc stopper
2
3
Rod stopper
(C/J version only)
3
4
DVD servo control board
CN101
A
Fig.1
Rod
T. Bracket
Fig.2
Lock lever
Fig.4
MX-DVB10
1
A
Clamper base
B
D
Return spring
5
1-17
Hide quick links:
Advertisement
Table of Contents
