JVC MX-DVB10 Service Manual page 15

< Main Speaker >
Removing the front cover
Remove the four screws marked A on the front of the
1.
body.
Remove the front cover from the four holders marked
2.
a that are fixing the front cover.
Pull out the front cover toward the front while
3.
disengaging the four joints marked a.
Note:
Because it is difficult to take away the cover,
insert a minus driver, etc. in the place between
the main body and the front cover as shown in
Fig.1 before removing the front cover. Exercise
care not to damage the main body and the front
cover when inserting the minus driver. For this
purpose, insert the minus driver together with
cloth and the like.
Removing the squawker
Prior to performing the following procedures, remove
the front cover.
1. Remove the two screws marked B on the front
cover.
2. Disconnect the yellow and black wires from the
speaker terminals on the squawker.
Removing the woofer
Prior to performing the following procedures, remove
the front cover.
1. Remove the four screws marked C .
2. Remove the woofer and disconnect the yellow and
black wires from the speaker terminals.
3. Remove the squawker and disconnect the yellow
and black wires from the speaker terminals.
(See Fig.1, 2)
A
A
Joints a
(See Fig.2)
B
(See Fig.2)
Front cover
Joints a
Fig.1
Joints a
Holder a
Tweeter
Holder a
Joints a
Fig.2
MX-DVB10
Front cover
A
A
Squawker
C
C
Woofer
1-15