Twisted Hobbys Crack Yak-55 lite series Manual page 9

Remove the little tabs of foam that are
in the SFG slots with a sharp knife
Glue the wings to the fuselage with
Welders. Notice how the tabs on each
wing prevent you from putting the
wings on upside down.
NOTE: USE GLUE SPARINGLY
AND WIPE OFF OR REMOVE ANY
EXCESS. TOO MUCH GLUE WILL
INCREASE THE A.U.W. AND
AFFECT THE MODEL'S FLYING
CHARACTERISTICS.
This is how the spar assembly goes
together. Short rod in the center first
followed by the longer rod over the top
of it.
Rev: 2012.11.04.v004a 9