Twisted Hobbys Crack Yak-55 lite series Manual page 11

Rev: 2012.11.04.v004a
Lay down a bead of Welders into the
rib and spar areas. Lower the assembly
into the provided slots allowing any
extra glue to squish out.
The short spar should be buried in the
middle section and the long spar
should be flush with the bottom of the
wing. The humps in the ribs will stick
out on both inner and out ribs as
shown.
Fill any voids with glue and wipe up as
much excess glue
Remember we want to keep things a
light as possible.
as possible.
11