Rigging Option 4A: Flown Four-Mini Array Using Universal Tilt Bracket, Msx Sub On Floor - Martin Audio MLA MINI Advanced User's Manual

MLA MINI
ADVANCED USER GUIDE
RIGGING OPTION 4A: FLOWN FOUR-MINI ARRAY USING UNIVERSAL TILT BRACKET,
MSX SUB ON FLOOR
The Universal Tilt Bracket may be used inverted (relative to its use with the Pole Mount), with a
standard Trigger Clamp attached to its 13 mm fixing hole instead of the boss that secures it to
the Pole Mount. For a four-cabinet array, this is the simpler method, and is ideal if a scaf pole
or truss is available. Note that 4 x Minis is the ONLY MLA configuration that may be flown using
this method; all other configurations MUST employ the Flying Frame.
This rigging option is suitable for use with Preset 5 when using a 4+1 configuration.
Step 1: Remove the Pole Mount boss from the Universal Tilt Bracket (if one is attached). Attach
a standard Trigger Clamp to the bracket's fixing hole with an M12 nut and bolt.
Start with the first four MLA Mini cabinets face down on their flightcase base. The cabinets
should be locked together with Flying Pins at the front and rear, with the rear pins in the '0.5'
position so that the four cabinets form a "flat" array. Attach the Universal Tilt Bracket to the
top of the first Mini. The lugs on the ends of the main cross-arm should mate with the slots in
the front corners of the cabinet. Secure these points with flying pins. Attach the rear lug of the
bracket to the Ground Stack hole in the cabinet's rear mounting plate. Secure with a Flying Pin.
MLA Mini Advanced User Guide V1.0
72