Configuring Teaming - D-Link DGE-560SX User Manual

NOTE: The recommended sequence is to load BASP.LAN before the network
drivers as outlined above. This allows BASP.LAN to determine the initial link state of
the bound adapters without delay.
Unloading BASP
To unload Broadcom Advanced Server Program, unload the adapter driver and the BASP
drivers.
For the adapter driver, at the Command Line Interface (CLI):
UNLOAD B57
The response is:
Module B57.LAN unloaded
For the BASP driver, at the Command Line Interface (CLI):
UNLOAD BASP
The response is:
Module BASP.LAN unloaded
NOTE: BASP can not be unloaded if one or more adapters are bound to BASP.

Configuring Teaming

NOTES:
Spanning Tree Protocol should be disabled on all switch ports to which
o
teamed adapters are connected.
If remote management (IPMI) is enabled on a device, the IPMI service could
o
be disrupted when the device is added to a team other than an SLB team.
Balance Mode Selection
D-Link DGE-560SX User Guide
59