Building The Driver From The Source Tar File - D-Link DGE-560SX User Manual

2.4.x kernels:
/lib/modules/kernel_version/kernel/drivers/net/tg3.o
2.4.x kernels with the tg3 driver patched in:
/lib/modules/kernel_version/kernel/drivers/addon/tg3/tg3.o
2.6.x kernels:
/lib/modules/kernel_version/kernel/drivers/net/tg3.ko
4. Load the driver.
modprobe tg3
To configure the network protocol and address, refer to the Linux version-specific
documentation.

Building the Driver from the Source TAR File

1. Create a directory (tg3-version) and extract the TAR files to the directory.
tar xvzf tg3-
2. Build the driver tg3.o as a loadable module for the running kernel.
version
CD tg3-
make clean
make; make install
3. Test the driver by loading it.
rmmod tg3
modprobe tg3
No message should be returned if this command runs properly.
NOTE: See the RPM instructions above for the location of the installed driver.
4. To configure network protocol and address, refer to the manuals supplied with your
operating system.
version
.tgz
40
D-Link DGE-560SX User Guide