Testing Network Connectivity - D-Link DGE-560SX User Manual

lsmod | grep tg3
If the driver is loaded, a line similar to the one below is displayed, where size is the size of the
driver in bytes, and n is the number of adapters configured.
Table 1: Linux Driver
Module Size Used by
TG3 size n

7.5 Testing Network Connectivity

NOTE: When using forced link speeds, verify that both the adapter and the switch are
forced to the same speed, or that both sides are configured for auto-negotiation.
Windows
Use the ping command to determine if the network connection is working.
NOTE: Network connectivity can also be tested using the Testing the Network feature in
Broadcom Advanced Control Suite 2.
1. Click Start, and then click Run.
2. Type cmd in the Open box, and then click OK.
3. Type ipconfig /all to view the network connection to be tested.
4. Type ping IP address, and then press ENTER.
The ping statistics that are displayed indicate whether the network connection is working or
not.
NetWare
Ping an IP host on the network to verify connection has been established:
From the command line, type ping IP address, and then press ENTER.
The ping statistics that are displayed indicate whether the network connection is working or
not.
Linux
D-Link DGE-560SX User Guide
143