Teaming With Channel Bonding; Netware Driver Software; Netware Core Driver Software - D-Link DGE-560SX User Manual

tg3: eth#: Flow control is configured for TX and for RX.
Link Up and Speed Indication
tg3: eth#: Link is up at 1000 Mbps, full duplex.
Link Down Indication
tg3: eth#: Link is down.

3.5.8 Teaming with Channel Bonding

With the TG3 driver, you can team adapters together using the bonding kernel module and a
channel bonding interface. Refer to your Red Hat documentation for more information on
Linux Channel Bonding.

3.6 NetWare Driver Software

3.6.1 NetWare Core Driver Software

Preinstallation Requirements
A network device driver must be installed before the D-Link NetXtreme Gigabit Ethernet
adapter can be used with your Novell NetWare system.
Before you can successfully install the adapter driver for Novell NetWare, the adapter card
must be physically installed in the system and, typically, NetWare operating system software
must already be running on the system. Make sure that your system meets the hardware and
operating system software requirements described in Installing the Hardware.
To enable the D-Link NetXtreme adapter to function correctly, you must install the latest
Novell NetWare support pack files. The NetWare support pack or patch file(s) needed for the
operating system running on your server are indicated below:
Table 1: NetWare Support Files
NetWare Support
Version Pack
NetWare Latest
5.1 support
Files to be Installed
The latest support pack can be found at:
http://download.novell.com/index.jsp?product_id=&search=Sea
43
D-Link DGE-560SX User Guide