Table of Contents
Advertisement
Detailed information on the LCM can be found in the Appendix.
See "Appendix A: The Command Line Interface" on page 107.
CONFIGURING THE DFL-M510
Before managing the DFL-M510, it must be initialized. This procedure is accomplished
through the DFL-M510 Command Line Interface. Access to the Command Line
Interface can be made either through SSH or from a terminal connected directly to the
DFL-M510.
You can use Hyper Terminal, SSH v2 or browser to set up the IP parameters of the
DFL-M510. The following are the default settings:
IP Address
Subnet Mask
Default Gateway
User name
Password
CONFIGURATION THROUGH THE COMMAND LINE INTERFACE
Configure the DFL-M510 using the following parameters.
The IP address shown below is only an example. Instead use the IP
address for your network.
IP Address
Subnet Mask
Default Gateway
1. Connect one end of the RS-232 cable to the console port on the DFL-M510 and the
other end to the COM1 or COM2 port on the PC. (The pin-out definitions are shown
below.)
Terminal Emulation
Bit per Second
3
192.168.1.1
255.255.255.0
192.168.1.254
admin
admin
192.168.62.100
255.255.255.0
192.168.62.1
VT-100, ANSI, or auto
115200
Advertisement
Table of Contents
